Open with table of contents

Testing your Mail Policy

After installing and configuring your Clearswift Gateway, you should test the system to check the effectiveness of your content security policy.

Modifying the Policy for Testing

You may find it useful to modify your content security policy for testing purposes to hold all processed messages, even clean ones. This will allow you to determine how Clearswift Gateway has processed each message.

If you are using the supplied starter policy, you can modify it to hold clean messages as follows:

1. Create a new disposal action to hold messages in a message area named, say, test-clean.
2. Edit the "Anyone to My Company" and "My Company to Anyone" policy routes to change their default disposal actions to your new "Hold in test-clean" disposal action.
3. Apply the configuration.

When you have finished testing, remember to reverse these policy edits and re-apply the configuration.

Testing Policy Routing

Try sending test messages into and out of the system to confirm the mail routes are producing the results you were expecting. From the Message Center you can view the policy summary for each held message. This tells you the mail route the message matched, as well as which content rules the message triggered and which nodes in the message caused those rules to trigger. For more information on viewing the policy summary for a held message, see Analyze and manage held messages.

© 1995–2018 Clearswift Ltd.