Open with table of contents

Ethernet Settings

The network settings displayed on the Ethernet Settings page describe the way your Gateway is configured to communicate with your network. These settings can be changed from the Clearswift Server Console or from within the user interface. See About the Server Console Interface for more information. The Gateway supports the use of multiple network interface controllers (NICs) and allows you to specify the primary and secondary IP address for the UI service.

Selecting an IP Address for the UI Service

To select the IP address of the UI service:

  1. From the System Center Home page, click System Settings > Ethernet Settings to display the Ethernet Settings page.
  2. In the Task Panel on the left, click Change IP Address for the UI Service to specify the primary IP address, or Change Secondary IP Address for the UI Service to specify the secondary IP address.
  3. Select an alternative IP address from the drop-down list.
  If you attempt to change the IP address for the UI service and you receive the warning that there are no un-allocated IP addresses, you must first define addresses in the Server Console.

Network Adapters

Use the Server Console Configure System > Configure Network Settings menu in the console to configure network adapters.

  If you are using the console to configure multiple network adapters, note that each adapter must operate on a different subnet.

See also...

© 1995–2019 Clearswift Ltd.