You can change the default
action
to be performed on requests and responses on the route, if required. The default action is the action Clearswift Gateway performs if no triggered content rule specifies an alternative
action.
To edit a web default action:
Move the pointer over the
By Default Perform This Action section
and click Click here to change these settings.
Select the default action
to perform, either Allow
the communication or Block
the communication using.
If you
select Block the communication using,
you must also specify a Block Page
to be displayed when communication on the route is blocked. The content
rules on this route will have no effect while the default action is block
and the block page cannot be overridden; all traffic on the route will
be blocked.
If you select Allow the communication, you can also specify that access is only permitted according to the Time Policy schedule. Click the Only when the schedule allows access check box and specify the block page to be used when the schedule prohibits access.
Select
Allow the user to continue browsing if
they acknowledge the block page to allow users to override the
block page.
You can select to display a Warning
Page. See End User & Block Pages for further
information.
Click Save.
If creating a new route,
the Using This Schedule section will be displayed for completion. See
Specifying the Time Policy Schedule
for more information about the Time Policy schedule.